Hollyland Pyro Ultra: Dual Receiver Setup Guide

By Filmgear Canada | Published: 2026-11-03

Category: Guide pratiche

Set up the Hollyland Pyro Ultra transmitter and dual receivers for two monitor positions. Follow the pairing order, channel plan, and power checks that prevent dropouts.

Quick answer

Set up the Hollyland Pyro Ultra transmitter and dual receivers by pairing each receiver to the transmitter one at a time, then confirming both feeds on separate monitor positions before you cable anything to set. This avoids the most common dual receiver mistake: pairing both receivers at once and losing track of which one is locked.

Why dual receivers change your setup order

A single receiver setup has one handshake to verify. The Pyro Ultra kit adds a second receiver, so you have two independent wireless links to confirm from the same camera source. If you pair both receivers in the same pass, a failed lock on one can look like a transmitter fault when it is really a receiver that never completed pairing.

Pair and verify one receiver at a time. Once both are locked, you can move them to their final positions and check that each monitor shows the same source without a splitter or second cable run after the receiver.

Plan the two positions before you power up

Decide who gets each feed: director plus DP, on-set monitor plus client village, or operator plus focus puller. The physical distance and obstructions at each position matter more than the order you unbox the kit, because a receiver that works beside the camera may struggle in a crowded client area.

If one position is far or heavily obstructed, treat that receiver as the one to test first. A weak link is easier to diagnose before the second receiver is in the mix.

Step-by-step Pyro Ultra dual receiver setup

Charge and power the transmitter and both receivers: Fully charge or connect power to all three units before pairing. Power the transmitter first, then receiver A, then receiver B. A receiver that dies mid-pairing is the most common reason a dual receiver rig appears to fail on the first attempt.
Pair receiver A to the transmitter: Follow the pairing procedure for the Pyro Ultra and confirm receiver A shows a stable link to the transmitter before touching receiver B. Do not pair both receivers in one pass; verify each lock separately.
Pair receiver B to the same transmitter: With receiver A still linked, pair receiver B and confirm it locks to the same transmitter. Check that both receivers show the same source. If receiver B will not lock, move it closer to the transmitter before assuming a hardware fault.
Assign a channel plan and check for interference: Set the wireless channel on the transmitter and confirm both receivers follow it. Scan or switch channels if either receiver shows an unstable link. Change channels on the transmitter first, then recheck both receivers rather than adjusting each receiver separately.
Connect each receiver to its monitor position: Cable receiver A to the first monitor and receiver B to the second. Confirm each monitor shows the camera feed independently. Test each monitor one at a time so a bad cable is not mistaken for a wireless dropout.
Walk the set and confirm both links at final positions: Move each receiver to its real position, with people and obstacles in place, and watch for dropouts on both monitors. A link that works at the cart but fails at the client village needs a position or channel change, not a new pairing.

Product facts

Hollyland Pyro Ultra Transmitter & Dual Receiver Set: The Hollyland Pyro Ultra kit includes one transmitter and two receivers, and each receiver decodes the wireless feed on its own. You can feed two separate monitor positions from one camera source without adding a splitter or a second cable run after the receiver.
Hollyland Pyro Ultra Transmitter & Dual Receiver Set