FPS Cine Stainless Steel 3-Riser Combo Stand: Setup Guide

Quick answer

Set up the FPS Cine Stainless Steel 3-Riser Combo Stand by spreading the legs on level ground, locking each riser before adding weight, and mounting your fixture using the correct junior or baby receiver. Always sandbag the stand and keep the heaviest load centered over the legs.

Step-by-step setup for the FPS Cine Stand

1. Choose a level, stable surface: Place the stand on solid, level ground. Avoid uneven pavement, grass, or ramps. If you must work on a slight slope, orient the legs so the heaviest load is on the downhill side and use extra sandbags. A level base is the foundation of a safe setup—never skip this check.
2. Spread the legs fully and lock them: Open each leg until it stops and engage the leg locks. Make sure all three legs are locked before you let go. A common mistake is leaving one leg partially folded, which makes the stand wobble. Push down on the stand to confirm all legs are locked before adding weight.
3. Extend the lowest riser first: Raise the bottom riser to the desired height and tighten its lock knob firmly. Extend the middle and top risers only as needed. Always extend from the bottom up to keep the center of gravity low. Never extend the top riser first—that makes the stand top-heavy. Check each lock knob by giving the riser a gentle tug—if it moves, tighten more.
4. Attach the fixture using the correct receiver: Identify whether your light or grip arm uses a junior (larger) or baby (smaller) spigot. Insert it into the matching receiver on the stand and tighten the locking knob. Do not force a baby spigot into a junior receiver or vice versa. If the fit feels loose, stop and check the receiver size—do not improvise with tape or shims.
5. Sandbag the stand before raising the load: Place at least one sandbag on the base of the stand, ideally over the leg that is opposite the heaviest side of the fixture. For tall extensions or heavy lights, use two sandbags. A common mistake is sandbagging after the light is already raised—always sandbag first. Sandbags are not optional for heavy fixtures; they are part of the setup.
6. Raise the load slowly and check balance: With the fixture attached and sandbags in place, raise the stand to its final height. Watch for any tipping or wobbling. If the stand feels unstable, lower it and adjust leg placement or add more weight. If you would not feel comfortable leaving the stand unattended, it is not safe yet.
7. Secure cables and do a final stability check: Run cables so they do not pull on the fixture or create a trip hazard. Give the stand a gentle nudge to confirm it is stable. Keep the load centered over the legs and avoid hanging anything on the risers that is not part of the fixture. A final nudge test takes seconds and prevents accidents.

Product facts

• FPS Cine Stainless Steel 3-Riser Combo Stand: Stainless steel construction makes it noticeably tougher than alloy stands when hanging real-weight fixtures. You can mount heavier cinema lights with confidence, but expect a heavier stand that needs careful lifting and positioning.

  

• FPS Cine Stainless Steel 3-Riser Combo Stand: Combo design takes both junior and baby receivers, so it mounts most cinema-grade lights and grip arms without an adapter. You save time on set by not hunting for adapters, but you must verify the receiver size before attaching any fixture.
• FPS Cine Stainless Steel 3-Riser Combo Stand: Three risers give you serious height for studio and location work. You can raise lights above tall subjects or create dramatic angles, but you need to extend risers carefully and sandbag the base.