Aputure NOVA 2x1 3-Light Yoke 套件 (裸線端)

Wired three of these into a single tie-in on set yesterday, and the bare ends made the whole process incredibly clean. The yoke arms held the panels perfectly steady even when we tilted them down at a 45-degree angle. Exactly what a gaffer needs for a permanent studio install.

The yoke arms are rock-solid and hold all three panels steady even when I tilt them hard for an overhead shot. Wiring the bare ends into our studio’s tie-in took my gaffer about twenty minutes total, and now we run all three off one circuit without any flicker.

The bare-end leads made wiring these into our studio’s tie-in a breeze, and the yoke feels solidly built. Took about ten minutes to get all three panels mounted and ready.