Selens Production Cart Wheels and Pole Setup: What to Know

Quick answer

Install the 8-inch wheels first, then mount the M28 main pole onto the cart frame before adding any other SCF2 attachments. Tighten wheel axles fully and confirm the pole seats flush before loading gear.

Step-by-step: wheels and pole installation

1. Prepare the cart and clear the work area: Lay the cart on a clean, flat surface with the wheel mounts accessible. Remove any existing wheels and set the cart frame on blocks so it cannot roll or tip during the swap. Check that all old hardware is removed before fitting new wheels; leftover spacers or bolts can prevent the 8-inch wheels from seating correctly.
2. Fit the 8-inch wheels one at a time: Mount each Selens 8-inch wheel to its corner, inserting the axle fully and tightening the retaining hardware by hand first. Confirm the wheel spins freely before moving to the next corner. A wheel that binds or wobbles after hand-tightening usually means the axle is not fully seated; fix it before final tightening.
3. Torque the wheel axles and lower the cart: Once all four wheels are on, tighten each axle to a firm, consistent feel and set the cart on the floor. Push it a short distance to check for tracking and any rubbing. If the cart pulls to one side, re-check axle tightness on the opposite corner before adjusting anything else.
4. Mount the M28 main pole to the cart frame: Insert the Selens M28 main pole into its receiver on the cart and confirm it seats flush. Tighten the pole's locking hardware so the pole cannot rotate or lift under load. A pole that rocks in its receiver will loosen under load; stop and reseat it before adding attachments.
5. Check pole height and vertical alignment: With the pole locked, check that it stands vertical and at the height you need for your tallest planned accessory. Adjust the receiver or pole position if it leans. Do this before mounting any SCF2 attachments, because changing pole height later means re-aligning everything mounted to it.
6. Add SCF2 attachments and test with a partial load: Mount your SCF2 accessories onto the pole, then load the cart with a partial gear load and roll it over a threshold or cable to check stability. If the cart feels top-heavy with a partial load, redistribute weight lower on the cart before adding the rest of your gear.

Product facts

• Selens Production Cart 8 Inch Wheels: Selens Production Cart 8-inch wheels are a replacement or upgrade wheel set for Selens production carts. Upgrading to 8-inch wheels is a direct swap on compatible Selens carts, so you can plan the install without adapting the frame.

  

• Selens M28 Main Pole || SAB13-500M28: The Selens SAB13-500M28 is the M28 main pole component used in the Selens SCF2 production-cart accessory ecosystem. It is the load-bearing pole that other SCF2 attachments mount onto, so its position determines where every other accessory sits.